Blob Noodlers - флекси-щелкающая игрушка для творчества и подставка для телефона

BLOB NOODLERS

IMPORTANT: Adjustment may be needed based on your printer, please read the instructions

Noodlers are cute little worm-like fidget toys that you can.. well.. noodle with! The ts rotate and snap in place to allow you to position Noodlers in a variety of different ways. You can twist two together and watch them spiral around each other, or you can weave them through your fingers. Noodlers can also be helpful! Turn a Noodler into a phone stand or a bag hook, and when you're finished noodling just wrap it around your bag or belt loop. There's even a bumpy Noodler and short Noodlers for whatever vibe you may be feeling.

Features
- rotating ts
- snaps to different positions
- phone stand feature
- bag hook feature
- print in parts or multicolor

Noodle Types
- normal
- bumpy
- short normal
- short bumpy

PERSONAL USE ONLY

Purchasing or ing this file does not give you the right to sell physical prints of this design. Commercial license is available for this design by subscribing to patreon.com/bloblab

COPYRIGHT PROTECTED FILES

All Blob Lab designs are protected under copyright law. Your purchase does not give you the right to sell or distribute the digital files in any way.

FILAMENTS

If you'd like to purchase the same filaments used in this design, please check out the Blob Lab Amazon Storefront link amazon.com/shop/bloblab3d

• .12mm layer height recommended for high quality
• 3 + perimeters for t strength
• print without s aside from custom piece under head (you can remove by right clicking and split to objects if you prefer to adjust)
• recommend to print at 210 C or cooler to keep ts from fusing
• after printing wait until the print cools down completely then gently twist to loosen ts
• if ts are too tight adjust the X-Y contour compensation by -0.1 mm
• print all parts on their flat side
• eyes snap into head, use superglue if too loose, scale parts or adjust X-Y compensation if needed
• 3MF files are for color information only, print settings may need to be adjusted