VenuSub Lock - Flat Rings V1 - Male Chastity System

VenuSub

Unlock The Goddess In You

The VenuSub Lock series of male chastity products are designed to make an easy-to-manufacture, easy-to-use, and highly comfortable chastity cage system which is secured with a traditional key and an integrated tube-style lock. This is preferable in situations where there is a keyholder, but the wearer wants the option to swap out cages quickly and easily with permission from the keyholder.

These are the first iteration of the flat rings. They the following cage options:
- VenuSub Lock External Flying Head Cages V1
- VenuSub Lock Flat Cages V1
- VenuSub Lock Inverted Cup Cages V1

There are numerous sizing options to allow an extremely customizable experience. If you need larger sizes, please let me know and I will make them and add them here for no additional cost.

Here is a guide to decoding the part numbers of the STL files:
VSL-RFL1-xx
VSL = VenuSub Lock series
RFL1 = Ring, FLat, version 1
xx = the size of the ring, in millimeters

Preferred Material: Unadulterated White ABS

Nozzle Size: 0.4mm or smaller
Layer Height: 0.2 mm
Outlines/Shells: 2
Infill: 100%
s: As fine as possible, 60 degrees (you can manually remove the s inside the harness loops if your slicer s it)
Additional Slicer Notes: Print the part as solid as possible.

Post Processing Suggestion:
1. Carefully remove the material with a small, firm object. I like to use the key to the lock I plan to use. Try not to break the thin geometry at the top of the locking area, but if you do cause a break while removing s don't worry, as the dipping process will re-adhere those layers.
2. Sand the rough edges and imperfections down using 220 grit sandpaper. (Make sure not to breathe in the dust!)
3. Dip just over half of the part in liquid acetone for 10 seconds. "Feather" the dipping line by gently moving/rotating the part so that the liquid interface is never in the same spot for more than a moment.
4. "Shake off" excess pooled acetone by moving your arm quickly in a circular motion 2-3 times, like you were preparing to throw the part. Make sure no liquid remains in the small holes or on the surface. DO NOT BLOW ON THE PART or you will get white spots.
5. Let dry for at least 10 minutes. Ideally you can hang the part with the hook only touching the dry area. DO NOT TOUCH THE WET SURFACE UNTIL THEN!
6. Dip the second half for 10 seconds, making sure not to miss any areas. Feather the dipping line again.
7. "Shake off" again, making sure no liquid acetone remains in the holes or on the surface.
8. Let dry for at least 10 minutes before handling gently, again hanging by the dry section you were grabbing.
9. Set the part in a safe place and allow to dry for a full 12-24 hours before use.

Additional Required Hardware:
Each VenuSub Lock cage and ring combo needs the following hardware:
- 1x Universal Tube-Style Chastity Lock

You can make the second emergency key able by encasing it in this key card.

The loops are designed for 10 meters of gutted 550 paracord with ends melted to a smooth taper. You can either tie a harness using all 3 loops, or just the top 2, depending on your personal preference.