Print in Place Pom Pom Maker

These files are for making a pom pom using yarn. There are sizes for 4cm, 5cm, 6cm, and 7cm. The sizes are debossed on the hinge. The clips print separately but the actual pom pom maker prints in place — no hardware or assembly needed. The clip is one size and works for all pom pom maker sizes.

Visual instructions are in the photos.
1. Attach clips. Push quickly to minimize stress on the clip. I broke a couple by taking too much time and being too careful! No issues after starting to push them quickly!
2. Hold two pieces of pom pom maker together so the bumps on each side are against the holes on the other side.
3. Wrap yarn around one side and fill up desired amount. Less will be a looser pom pom and more will be a full and tight pom pom.
4. Flip to the other side and repeat. No need to trim yarn when switching sides, it’s easier if you don’t.
5. Close pieces and snap clips closed.
6. Cut the yarn tail from your skein of yarn to detach. Use sharp scissors to cut around outside in the slot between the two pieces. (The bumps on the pieces are what allows this space to get your scissors in.)
7. Take a long piece of yarn (8-10” or so) and push it in slot on one side in the center of the long strand so there is an equal amount on each side. Push it hard, it will need to work its way past those bumps.
8. Flip pieces over and do a tight square knot (tight enough that you feel like you might break the yarn, otherwise your pom pom will fall apart.) Flip once more and repeat a knot on the other side. This holds the pom pom together so make sure it’s tight.
9. Unclip and open pom pom maker pieces. Remove pom pom.
10. Rub pom pom between palms and gently pinch and tug the strands a little to fluff up.
11. Leave the long tail if you plan to attach to your project! Trim around pom pom to make it round.

Fun fact: there are people on Etsy willing to buy untrimmed pom poms!
Tip: Using multiple strands at once will fill up your pom pom quicker!

Print two clips and two pom pom maker pieces. I used tree/organic s for the pom pom maker pieces. (See photos; I used a little more for the bigger sizes.) It prints upright (like a mountain.) I tested multiple orientations and this is the only one that works and works perfectly. I have it positioned so the smaller end is slightly lifted from the bed to allow s under it. After you carefully remove the s, make sure the gaps are present in the t pieces. Some of my prints ended up closing right away and some needed some assistance. If they are fused together (likely from material being left behind), you’ll need to work them apart with your thumbnail or other tool. Then you’ll have to carefully release it. Hold the pieces right at the t with your hands on each side and start wiggling it. You might need a little force to release it. I did a whole bunch of test pieces and never broke the t.
My settings:
Layer height: .12mm (I imagine a larger layer hight wouldn’t be great against the yarn because it wouldn’t be so smooth.)
Perimeters/walls: 3
Infill: 25%
Same settings for clip, no s needed.