多色迷你电池模型

I printed this for my son's school science project using the colors I had available. Sliced with Cura 5.0.0. The small features are a bit fiddly to clean up, in hindsight I wish I had scaled up the model to at least 150%. Other than that, it printed neatly, without any s. Most of the parts were printed using 0.2mm layer height, except for the really small bits, which were printed with 0.1mm. I tried to use ironing for the cytosol (flat white part) so it would be flatter and thus easier to glue the smaller bits onto it, but for some reason it came out looking worse than the non-ironed part in the picture. After some bed levelling, I successfully used ironing on the flat part of the nucleus.