Крошечный (относительно) карликовый Цеппелин

A small (not really) zeppelin to give some air superiority to your dwarfs!

The story is short: I wanted a zeppelin for my new Warmaster dwarf army and I didn't find anything I really liked, so I took the best pieces of everything I found and built my own zeppelin.

Since there are no official rules to use it in the game, I took the liberty of playing around with some ideas and in the end I decided that this zeppelin would be equipped with a conventional cannon and four "machine guns" (my idea is that they work in a similar way to imperial volleygun).

I plan to the rules to use it in the game, but I need to do some playtesting before sharing anything.

Now, a few notes regarding the impression that I should mention:

First, the balloon: I printed it in PLA only because my resin printer (a Halot One) is very small and I also felt that it was going to be too much for it, but if you have a printer with more testosterone than mine, I think you can try printing both parts in resin (don't forget to hollow them out).

Second, the gondola: I printed this in resin, but for the same reason as before, I did it in separate pieces. The problem I had was that I experienced some warping (I don't have much experience printing large, flat pieces), as a result ugly gaps were created between the pieces which I was forced to fill with epoxy putty and covered with a decorative trim that i sculpted by hand (which, for obvious reasons, is not included in the 3d model). I think the ideal is to print the entire gondola at once, although I cannot guarantee that it will turn out well, that depends on how you configure the model in the slicer, the s and your printer.

Additionally, the anchors are fragile and may break or not print correctly, as happened to me. That's why I included a small anchor model in case you need to repair this piece.

Third, the base: If you are going to print it in PLA, I strongly recommend that you print the rod horizontally, that way you will give it much more resistance than if you print it vertically. I designed it to be inserted into the base from below. On the other hand, if you want to print the base and the rod in resin, I can't do anything other than wish you good luck xD