Фигурка Helldivers Action Figure (Posable)

First Helldiver Action Figure.

You can change size of the print but this is the main size that was tested.

For now to print another leg and arm you need to mirror it.

Instruction:

• Prepare:

Hair Dryer - for easier and safer assembly
(optional) Glue - for holding few parts if needed and increasing friction

• Print without Mirror:

2x Elbows
2x Feet Connectors
2x Connector Basic
2x Shoulder Connectors
2x Leg Connectors
2x Knee
1x Chest with s
1x Pelvis with s
1x Neck
1x Head
1x Cape
1x Chest and Stomach Connector

Print on part normally and one with mirror:

2x Forearm
2x Hand Open
2x Hand Fist
2x Hand Salute
2x Hand with Gun
2x Hand Second Hand Gun Holding
2x Shoulder Helldiver
2x Thigh
2x Biceps
2x Feet Part 1
2x Feet Part 2
2x Leg

It's Advised to print more tiny parts in case it breaks during assembling for the first time.

• Everytime before connecting parts, heat them both for easier assembly and to prevent fractures.

Assembly the parts as shown on the photo/GIF video.

• If you want better friction, you can use a little bit of glue on connecting/moving part and move it around every few second until it gets dry. BE CAREFUL with this technique, the more glue you will use the longer it takes to dry, you wait without movement for few second because you forget then it might stick together and it might brake.

Tested with Anycubic Photon Mono 4K resin printer. Tested with standard Anycubic Resin