gCreate Rocket

I made it into a night light, and added a base for the power switch and the cord. The power supply, switch and connector, came from an old USB disk drive case.

I hogged out the inside of the rocket, printed a cylinder to stick the LEDs to and glued it in. There are also some LEDs around the inside of the nozzel. There wasn't enough room to route the wires between the rocket body and the nozzel, so I ran the wires outside and made them look like hoses.

Also, I used Meshmixer to split the rocket body into 3 parts, so I could print it without s. It is all PLA and I hope to paint it soon. McMaven.