Skip to content

Thumb Splint/Protector

Advertising
?
Make’s quality: 0/5 (0 votes)
Evaluation of on the quality of 3D print, material, post-processing, photo, etc.


Publication date 2024-08-14 at 15:57
Maker
3D Model
Advertising

Make’s description

As my thumb healed and the back area became lesss sensitive I switched to the open top design.

Again, using the hair dryer on the plastic for a few seconds at a time gradually heats the plastic making it more maluable and place it over my thumb so i could further custom mold the piece.

This does not have to happen but worked great for me.

I ended up tying up the splint and have since switched to an elastic strap that has been working great.

I found that s were not nessecary but if you are unsure include them just to be safe.

3D Printer

CR10

Filament

PLA
  • Raft: No
  • Resolution: 0.2 mm
  • Temperature: 190 ℃
  • : No
  • Infill: 20 %
  • Speed: 55 mm/s
You have a problem with this Make? Report a problem.

Other makes from the same 3D model

Add a comment