Sword and snake book protector

Parameter Recommended value
Nozzle 0.4 mm
Layer height 0.12 mm (for fine details)
Print speed 40 mm/s (slower = more detail)
Nozzle temperature 200-205 °C (PLA) / 210-220 °C (PETG)
Bed temperature 60 °C (PLA) / 70 °C (PETG)
Shrinkage 0.8 mm @ 40 mm/s (Direct Drive)
Fan 100% (except first 5 layers)

🧱 Special configuration for model
Specific configuration Suggested value
Infill 15-20% (Gyroid or Cubic for good stability)
Top/bottom layers 5-6 layers
Wall layers (perimeters) 3
s Only if overhangs greater than 45° (sword or raised decorations)
Adhesion to bed Brim (to avoid warping in corners)
Recommended material type PLA (detail and ease) or PETG (more resistant).