Neco-Arc eats Corndog.

EDIT: author has updated the model since this make post!

Had to flip it upside down for sanity.
It failed on the first print because the corndog kept wiggling as the extruder worked on it, eventually unsticking off so after reapplying a vigorous amount of glue stick it succeeded on the second print.

Tragically, the corndog is the major weak point in this model, so it didn't survive the removal off the bed. And this print CANNOT stand as the feet aren't flat to the ground nor is the center mass balanced.

Print settings:
Orcaslicer (fine preset)
layer height 0.16mm
<10% sparse infill - Gyroid
Tree s (no double walls, and as slightly thinned)
Scaled up to 75mm in height(Z)

If I want to insure the corndog to not break on my next try, I'd either scale it up or manually edit the model for a thicker connection (disguised as neco arc's thumb) or dripping ketchup/cheese.

Otherwise it can be glued back together ezpz