Skip to content

Hulk 3D Scan

Advertising
?
Make’s quality: 0/5 (0 votes)
Evaluation of on the quality of 3D print, material, post-processing, photo, etc.


Publication date 2024-05-18 at 01:14
?
Published to Thingiverse on: 2016-09-26 at 00:28
Maker
3D Model
Advertising

Make’s description

The Hulk - Glow in the Dark Green!

What an Incredible (pun intended) Hulk print this was... the details on the print are amazing and more so once it is glowing in the dark...! I'm including a dark picture just to give an idea of what it is like (although it doesn't even make it justice, really)

  • CTC Dual Extruder Printer
  • Glow in the dark Green ABS
  • 100 micron resolution, 100 mm/sec travel rate, 40 mm/sec feed rate, 230º Extruder temp, 130º heat bed temp, shells = 0, raft and full s (using replicatorG Sailfish 40r33 + Sailfish 7.7 firmware)
  • the print job took around 33h to finish

Once I have the time, I will clean it up some more, polish it on some acetone vapour bath and finally spray paint the shorts and the hair and mouth...!

You have a problem with this Make? Report a problem.

Other makes from the same 3D model

Add a comment