Arduino Mega snug case
Advertising
- 27 views
- 0 likes
- 0 comments
| Publication date | 2024-05-18 at 07:19
?
Published to Thingiverse on: 2017-03-29 at 15:45
|
|---|
Maker
3D Model
Advertising
Makeβs description
The bottom part fits nicely around my clone. I can't get the top on because the slots are too thin. The pin holes on my board came bent slightly, I tried bending them back but could not bend them enough for the top of the case to fit.
NOTE: the model is fine, by board is the problem
You have a problem with this Make? Report a problem.
Add a comment