Complete Pack Velocista Line Follower Workshop , design, Materials , Code , Stl , diagrams , videotutorials

📦 Complete Pack of Line Follower Workshop at Cults

After the resounding success of our line follower workshop editions, we decided to all the information here to Cults. Thank you for your interest in competitive robotics! 🚀

💡 What will you learn?

This pack offers a complete guide for you to build your own line follower, from design to programming. It is ideal for robotics competitions and for those looking for hands-on, detailed learning.

📹 Video tutorials included!

Each of the 9 topics of the course has its own explanatory video tutorial, which will be available on our YouTube channel.

🔍 Course Content

• Introduction to line followers 🚗

• Introduction to EasyEDA 💻

• Basic PCB design 🛠️

• PCB PCB assembly 🔩

• Preparation for 3D printing 🖨️

• Line follower assembly 🏗️

• Introduction to Arduino 🌟

• Line follower programming 📝

• Track testing and practical tips 🏁

🛠️ What will you find in this pack?

✅ Competition code: Track optimized code.

✅ Gerber design and electronic schematic: To fabricate and connect the circuits.

✅ 3D design of the base and fasteners (STLs): Ready to print.

✅ Additional PDFs: Detailed course information.

✅ Track layout: Print-ready format for banner and practice.

💵 How to purchase the pack?

From Cults you can buy the pack to the project and contribute to the creation of more complete tutorials like this one.

International payments:

💳 PayPal

Payments in Peru:

Bank transfers: B / Interbank

YAPE or PLIN:** +51914130347

💬 Doubts?

me directly by WhatsApp at +51914130347 and we will coordinate the purchase at your convenience.

---

your pack and get started today!

This is your time to learn, compete and win in the world of robotics.Thanks for your and see you on the track! 🤖✨

⚙️ Recommended 3D Printing Settings for the Line Follower Base

🧵 Material (Filament)

• PLA+: Easy to print, economical and with good precision.
  

🌡️ Printing Temperature

• 190 - 210 °C

*(Check specific filament manufacturer's recommendations).

🔥 Bed Temperature.

• 50 - 60 °C

(Apply glue or blue tape to the bed if necessary to improve adhesion.).

📏 Resolution (Coating Height)

• 0.2 mm:** Balance between speed and quality.

• 0.1 mm:** More detail if you are looking for a finer finish.

🚀 Print Speed

• 40 - 60 mm/s for general parts.
  

(In complex areas, reduce to 30 mm/s.).

🏗️ Infill (Infill)

• 20 - 30%: For a solid and light base.

• Pattern:** Hexagonal or grid pattern for strength.

🛠️ Brackets

• Yes, only where necessary *(for projections greater than 45°).

• Configure brackets so they are easy to remove without damaging the part.

🛏️ Bedding Adhesion

• Brim (skirt): Recommended to avoid deformation (warping).

• If the bed is properly leveled, raft will not be necessary.

🔄 Retraction

• 1 - 1.5 mm at 30 mm/s

(Adjust according to your printer to avoid strings or *stringing.)*

⏳ Estimated Time to Print.

• Depending on the design and layer height, it may take between 3 and 6 hours for a medium sized base.