Flexi Capy Snek - Commercial License

This is a Commercial Licensed version of an Articulated Skeleton 'Snake' with a Capybara Skull
Version 1.2 - 29 XI 2024

More about a license above 'Print settings' section

---

FREE version for Personal Use Only is here:
https://cults3d.sitegames.net/en/creations/flexi-capy-snek

Models are the same

---

Capybara Skull is followed by 20 spine segments (12 in short version)
130mm length total (short version is 92mm)

Original model is printed straight but if you want to print it as big as you can there is an Arc version (the same model but bended - wich uses more square space with more optimal way)

There is also a SHORT version (12 segments instead of 20) and on the base of that two keyrings models
You can have a ring on the back (last segment is with a hole) or in the front (lower teeth removed, upper teeth connected to jaw)

---

More Halloween models:
https://cults3d.sitegames.net/en/design-collections/c47/halloween

Short video with a Capy Snek
https://www.instagram.com/c47_3d/reel/DBOimvOtc7v/

---

With this Commercial License you are authorized to:

Print — sell and distribute 3D prints of this 3D models and its adapted models for any use, including commercial use, in unlimited quantities;
Adapt — remix, transform and create from the digital files of the 3D model

What is not allowed:

No sharing of your 3D prints, nor adaptation of the 3D model without attribution.
No distribution, sale, donation or exchange of the digital files of the 3D model and the digital files of 3D models adapted from it.

---

If you will need any help with this models just write here or on my Instagram

If you want to sell just few prints or want to sell it for some charity you can write to me too - this refers to every models of mine

---

2-3 walls
No infill needed
No s needed

You can resize it as you like

Break possible connections between segments after print
With a clean print it will be moving like it should streight from the bed plate

---

You will need a good bed adhesion to print it without any problems - The best would be to use a glue stick

Most difficult is front teeth part - it's small and it's also ing a front part of a skull

Brim to the whole model is not recommended (too much work with removing it)
If you need some help with adhesion of front teeth use 'Teeth-brim' model
It will add 2-3 walls around teeth on the first layer
Ignore model errors - there is a flat part to help you line up the model with CapySnek
Also click 'NO' if the slicer will want to automaticly resize the model - it's with the right size but it's small
There are brim files for streight model, arc model and short (this one will also work with keyring-back version, keyring-front doesn't need brim)

---