AMS STAND PRO MODEL drawer system Expansion pack 2

Then I added another expansion pack to my AMS STAND, this drawer system has the same design as the stand itself. It is possible to print it both with and without nozzle stands and the inner drawers. The many small drawers are perfect for all the many small parts that you replace on the printer when they wear out. there is room to put your tools at the bottom and there is room for tweezers and knives and pencils etc.

Please read my description before you buy my designs, especially if you want to add expansion packs, you must be sure that you buy the right expansion packs, and it appears in my description what goes together

See the assembly instructions on Youtube
https://www.youtube.com/watch?v=ZIUpswprX3U&t=3s

To use the correct screws in the correct holes, look in the TAP hole to see if it says A or B, which is also shown on the screws

Use the Complete file. It contains all the parts needed and the right amount

Use a good glue to glue the Jalousie door together in the 3 ts

This is drawer section ONLY follow link to AMS Stand and Build Plate Garage

https://cults3d.sitegames.net/en/3d-model/various/ams-stand-expansion-pack-1

All files contain the settings that I recommend, be aware that is set up to be PETG while the print itself is PLA, if you do not have the option, you must to change the settings.

Jalousie door must be printed in PETG and must be printed at a 45 degree angle

I recommend adding reinforced areas at all ts, watch my how-to video, access video here! https://www.youtube.com/watch?
v=u3M6P5c4IiI

I also recommend adding PETG as , this gives a very precise hole for the ts. watch my video how to do this. access video here! https://www.youtube.com/watch?v=Lf1iQYXnVdU