Paw Patrol Logo Multipiece Fondant Cookie Cutter Set Multiple Sizes

Paw Patrol Logo Multipiece Fondant Cookie Cutter sets. This set includes STLs for all the cookie cutters to make this item with fondant or dough. The 2" and 3" sizes do not have the "Patrol" word cutter since it would be too small to cut properly. This file set includes each cutter set in the following sizes:
2"
3"
4"
5.5"
7"
9"
11"

This cutter set size is measured by the width of the entire design. So the 4" will create a 4" wide logo. The 4" size is pictured above.

Every cutter has a 3 tier cutting lip to guarantee a clean cut every time.

Print cookie cutters in PLA. My cutters have a proprietary 3 tier cutting lip for the cleanest cuts every time! Ensure that your "thin walls" setting is turned on for best results. You should not see any "infill" in the walls in your slicer. You should see 4 printed walls in the cutting wall section of these cutters.

Wash cutters in cold water with soap as hot will cause them to warp.

Scaling these prints in the slicer will not work since the cutter sides are engineered to be exactly 4 walls thick.

Settings from my prints:
Nozzle: 0.4mm
Layer Height 0.3mm
Infill: 0
Thin Walls: ON