Zapotec organizers

Organizers for Zapotec board game. Quick game set up and comfort during the play. Sliding lids prevent components from falling out during the storage. Theme reliefs and cutouts decorate organizers.

The set contains: Player Layout organizer + Collective organizer, Resources organizer, Set up organizer and Trade organizer.

1. PLAYER LAYOUT ORGANIZER: All one player's components are accommodated here. The organizer corresponds with the arrangement on the player's board. Additionally a section for discs is provided. Palace tile is inserted into a slot on the top. Small threshold prevents it from sliding out too easily. All compartments are thoroughly designed and are very well adjusted to components. Indentations facilitate taking Pyramid pieces out.
2. PLAYER COLLECTIVE ORGANIZER: Layout organizers are stored in pairs in 2 Collective organizers. The space inside Collective organizer is adjusted to the height of the Layout organizer with components. The lid covers it properly. Thus everything is well protected from falling out during the storage. One Collective organizer contains 2 Layout organizers. Indentations facilitate taking Layout organizers out. Reference cards are stored under the Layout organizers. There is a hole in the center of the lid that corresponds with the partition wall of the container. You can grab the wall through the hole to pick up the container during the unpacking. It's easier when Layout organizers are arranged in opposite directions.
3. RESOURCES ORGANIZER: 6 types of resources are organized in 6 identical sections. 2 of such organizers should be 3d printed. Thus, they can be placed on 2 sides of the table during the play, so all players can reach for resources easily. Still, one organizer can contain all resources tokens.
4. SET UP ORGANIZER: Different components that are used during the set up are accommodated here: 3 card decks, Building and Palace tiles. Sections for cards can contain sleeved cards. Sloped bottom and indentations facilitate the draw. Again, holes in the lid provide access to the partition wall that can be grabbed to take the container out of the game box.
5. TRADE ORGANIZER: 3 types of Trade tiles are kept here separately. Stacks arrangement corresponds with the game board, so the organizer can be placed directly in Trades location. Indentations facilitate taking tile out.

All organizers fit the game box very well and provide quick game setup. However it's not an insert.

More photos in higher resolution:
The set and game set up for 4 players
Packing steps
Player Layout organizers + Collective organizers
Resources organizer
Set up organizer

All organizers were 3Dprinted on Prusa MK4 (with Input Shaper):
- in PLA (Nebula Green Grass),
- No is needed,
- Infill 10% gyroid,
- 8 top layers.
Note1: Printing settings with 0.15 mm layer height are recommended for organizers with lids, so they work smoothly. I used slightly changed default Print settings "0.15mm SPEED MK4" in PrusaSlicer.
Note2: Player Layout organizers (with no lid) were 3d printed with 0.20 mm layer height settings.
Note3: The largest is Set up organizer: 117 x 218 mm.

Printing Time (for one piece of each kind):
1h42' - Player Layout organizer, x4
3h9' - Player Collective organizer, container, x2
2h41' - Player Collective organizer, lid, x2
3h45' - Resources organizer, container, x2
1h35' - Resources organizer, lid, x2
6h9' - Set up organizer, container
2h7' - Set up organizer, lid
1h51' - Trade organizer, container
29' - Trade organizer, lid