CSCustoms CS2.10 Buggy 2WD

Hello Guys,

This is my Biggest Project so far. My personal Goal is, to create a Mostly 3D printed 2WD Chassis for Competition use.

The Project currently is in development state, but as so many People asked for the Files i finally decided to share the Files.

UPDATE!

There is a Team Assotiation B7 Compatible Version in The Zip Folder.

You will need:

• Differential

-Front Axes and Bearings

-Rear CVDs

-39T Idle Gear from Asso

-Slipper Clutch and The complete Axe with Spur Gear

-Motor Mount

You will need some Parts from an old SWorkZ S12-1M.

-Rear Differential

-Rear Axes (CVDs)

-Wheel Hex-Adapters

-Idle Gear (the brass one with 34T)

-Slipper clutch With Spur Gear and the whole Axe with the 20T Gear

-Front Axes (other 5mm Axes will also Fit. There are two 10x5x4 Bearings in the Front steering knuckle)

-Some Oil shocks (80mm front and 95mm rear hole distance)

-Four 3mm x 40mm Steel Axes

-A 3mm Drill (or 3.1 for the wishbones) to Make the Axes go smooth and make the holes where you push the screws through.

-Bearings: 6-15x10x4mm

                    8-10x5x4mm


                    2-12x6x4mm


                   2-6x3x2.5mm

4-3x40mm steel Axes

Also you will need a assortment of countersunk screws (8 to 30mm) m3 and lens head screws m3 (6mm to 25mm)

3-M4 Nuts and one m4x25mm and two m4x40 cylinder head screws.

If you have any Questions, pls me on Facebook in my Group. Some Parts will need s. Print the Parts with maximum strenght, not minimum s!

All Parts are printed in 100 Percent Infill with PETG-CF. The whole car weighs approx 1.5 kg.

FDM Print

PETG-CF

100 Percent Infill

s needed

Some Parts you Need to Mirrir on Y-Axe in you slicer like wishbones, Knuckles and C-Hub.