Hello !
I have just finish 3D printing the first plate with the 56 first parts of the puzzle. The quality looks fine and I am willing to print the next 3 boards.
However, I had an issue with the printing of the part #7. The bottom right part was twisted on its before being connected to the left part. The results is that I have an opening of about 2 mm between the main part and its bottom right corner.
Could you provide the 3D file of this unique part or is there a way to select only one part of the complete plate to avoid printing again the 56 parts for only one with a defect ?
Thanks for your help !
- 0 likes
@UHGUES: Hey, it's quite straight forward to pick out a specific piece from one of the plates by using, for example, Meshmixer (free tool, very useful). You load it in, select 'separate shells', then you click on the piece(s) you want and export them out as another stl file. (Make sure you have 'export selection only' active in the preferences). You can also PM me over at facebook and I give you a file that has all the pieces split up into separate files.
Hope this helps.