Amazing Amy - Back 2 Black - by SPARX

Continuing my sculpting of movie and music icons how could I not include Amy Winehouse?
As I searched for images for reference, I decided on the MTV 2007 “Rehab” performance as the clothing for the model . . . however it was clear that her hair and clothing hid some of her tattoo’s, so I have included a second clothed figure in her Virgin Festival performance also in 2007.
The parts are not interchangeable between the two models (apart from the heads) due to the cuts needed to create the models.

Like the “SIMPLY MARILYN - BY SPARX” model available here;
https://cults3d.sitegames.net/en/3d-model/art/simply-marilyn-by-sparx
I will not produce any adult themed parts for this sculpture.

The tattoos are included as a zip file and I used waterslide paper to print and apply to my model.

Based on Amy’s Measurements at the time of 36(32D Cup)-23-33 and 5Feet 3inches or 160cm Tall (Flat Feet) the Model is 1/6th scale therefore would be 267mm standing (not including “Beehive!”)
So model in “Heels” with base 312mm height, model in “Flats” with base 302mm height.

“Rehab” parts
2 Arms
1 Upper Torso Dress
1 Lower torso Skirt simple
2 Legs simple
1 Lower torso Skirt with knicks
2 Legs long
1 Mic base
1 Mic base & bottom pole
1 Mic upper pole
1 Base one piece

“2007” parts
1 Left arm
2 Legs
1 Upper Torso TEE
1 Lower torso Shorts
1 Base one piece

Also includes interchangeable parts
2 Heads

Bonus parts
1 Head stand
1 sheet of Tattoo’s

24 items in total.

PURCHASE OF THESE FILES DOES NOT ALLOW SELLING STL FILES OR MODELS MADE FROM THE FILES. . . IS FOR SINGLE BUYER USE ONLY

I SHARE MY WORK FOR OTHERS TO ENJOY. . .PLEASE DO NOT SHARE THESE FILES ON SOCIAL MEDIA OR OTHER WEBSITES. LINKS TO THIS PAGE ARE ACCEPTED

All parts are cut files to fit build plate of small resin printers like the Photon or have separate files than the FDM versions included.
These orientations work for FDM printing but you may find a better orientation that reduces .
All the parts have been printed and developed to print, A lot of prints have been produced to get the figures corrected and fault free.

Why cut into many smaller parts I have been asked?
1. If you try and assemble this, then paint it . .it would be difficult to paint into hidden areas, less masking when painting separate parts.
2. Smaller parts not only allow for Resin print at full scale, but also allow individual parts to use less s than one larger part on FDM printers
So now you know!
Please do not scale down or adjust my recommended settings for infill etc. . . as you can see from the pictures this prints very well and I believe you will be pleased with the result when completed.
All of my models are only released when they can print! so please do not remix or "fix" faults in this model then republish! If there is a fault then let me know . . message me I will answer and fix problem. . apart from that print, make, enjoy.

3D PRINTING SETTINGS

Resin Printing;
Hollow 2.40 Raft 100%
Head, Legs

Hollow 2.70 Raft 100%
Upper & Lower torso

DO NOT Hollow
Arms, microphone parts

FDM
Arm, Head, 80% fill 0.12 speed 40
Rest at 0.16 30% fill, speed 50

ALWAYS dry assemble and “trim” parts prior gluing.
Look at the picture of how to assemble parts, so that you construct and paint separate before ing should you wish.
The Rehab right arm can take a magnet fitting to assist in assembling to the microphone.