Sovol SV08 Makro-Ergänzungen + einfache Upgrade-STLs

Does File > Import > Import configs not work? Make sure to have the stock SV08 presets enabled, this will create derivative presets for those.

I was trying to figure out how to import them not very good with computers

If yo could tell me how and where to import them and thanks for the help

Oh, sorry. Inside Orca Slicer, use the menu commands. You might have to extract the zip file somewhere before you can import them. Sorry, I cannot really give you more help. Maybe I'll demo it in a future video, good idea. But if you look at the description, I've provided the few changes there too, which you can just add manually in the stock SV08 presets.

Go to line 441 in "printer.cfg" once you click the machine tab in klipper. Change the timeout Value to "timeout: 3600" this will allow up to 1 hour

You should run the nozzle clean before doing a bed mesh

Sorry, I looked into the folder and it shows all of them in version 4.

Yes, that’s correct — just v4. I keep the older versions available in case someone doesn’t like any changes between versions, but so far, nobody has reported any issues with any of them.

You could add the macro call in there qgl macro. I wouldn't though. There are small prints when you don't need so long heat soak. Also if you follow a previous print you wouldn't need to soak for so long. Also, the way I recommend is to turn on the printer before a print, and immediately you can start the heat soak, while you prepare the model in the slicer. It would add to the print time if the soak would only start with the print.

Yes, this is a system setting. By default idle timeout is set to 15 minutes on the SV08. Please see the description above, I've now included the lines you can change in printer.cfg to extend the idle timeout. I also included a screenshot of the setting.

Thank you for the recommendation!

I've been looking for a sovol discord - what is the link

https://discord.com/invite/uZsKjTWx

Yes, it works the same way for me. I don't mind the long beep, it reminds me to turn it off quickly. But probably increasing the delay at the end of the macro should fix the fickleness. As for the blinking light, it is supposed to dim, but Sovol has the LED configured wrong. You should update cycle_time: 0.01 in the section [output_pin main_led].