putin sound system

#BCN3DCULTS

This is my putin speaker system with a 5 inch car speaker
I love it and people always talk about it.
The Left speaker is my favourite because its half Putin/half terminator.
He is the Putinator
they both took me about 50 hours each.
They stand at 55 centimetres tall.
The heads were printed with their back towards the printing bed.
The base, the shirt holder and the shirt are the same in both.
The heads were printed at 50 microns, the rest at 100 microns.

My 3d printer does not allow me to change the amount of infill so there was a lot of filament and time wasted because I had to remove the infill inside of the head (Lobotomy) to allow room for the speakers.
I have added the make up photos ( filing and adding putty on ts of the parts prior painting it chrome.
then my final photoshoot

here are a couple of youtube videos of it in action before they were painted:
https://youtu.be/qB7VM0MN8gw

https://youtu.be/zp1rqL51bdA

https://youtu.be/vmjoTF0PGAs

(look at how much infill it printed with, i wish i could select how much or less to go into the 3D print in my 3D printer software)

AND CHECK THIS OUT:

http://www.ministryofsound.com/magazine/2016/02/10/vladimir-putin-soundsystem